Kitchen Divider (Continued)
The upper section is fastened to the ceiling with two 2x3's 70 1/2 " long. Bevel one edge of each to match the slant of the sides. Locate these carefully on the ceiling and fasten them to the joists with lag screws about 4" long. If you find that the joists run parallel with the cabinet, use five short lengths of 2x3 running crosswise to form the fastening. Support the cabinet on boxes or blocks and raise it snug against the ceiling with wedges. Fasten with screws driven through the sides and ends into the 2x3's. Mount fluorescent lamps under the cabinets as shown in the drawing.
Built-In Electric Range
GENERAL ELECTRIC MAKES THIS OVEN AND SURFACE UNIT IN A SINGLE MODEL. THERE IS PUSHBUTTON CONTROL FOR THE SURFACE UNITS, AND A 32" LONG FLEXIBLE CABLE PERMITS THE control panel to be mounted in the wall above or in the cabinet front below as shown in the photograph. The surface unit uses sealed-tight sink-rim construction. The drip trays are cleaned by removing them through the cabinet doors. Colors available are yellow, turquoise green, brown, blue, pink and white. In addition, the surface-unit surround can also be had in stainless steel.
Gas Oven And Surface Units CHAMBERS MAKES AN OVEN THAT IS AVAILABLE IN EITHER STAINLESS STEEL OR ANTIQUE COPPER, FINISHED ON SIDES AND TOP AS WELL AS FRONT FOR MOUNTING ON A CABINET